SE Caster encoder

[TheNerd]

I have been using BUTT with no issues. but it only allows to connect to one stream at a time. I decided to give SE Caster a try. It seems at though everything loaded correctly. the meter is picking up my playout fine, the encoder connects to my streaming service. However, there is no audio, just static(white noise). 

Current configuration: RadioDJ(v2) and Mic into Voicemeeter, Voicemeeter into encoder. Encoder into stream(mp3). All settings are identical. BUTT works fine, SE Caster (static).

Did I miss something in the setup.

[ghm72]

That's rather strange I've not had white noise using SE caster does it happen if you try other encoding software?

[Brodephat]

I have been using BUTT with no issues. but it only allows to connect to one stream at a time. I decided to give SE Caster a try. It seems at though everything loaded correctly. the meter is picking up my playout fine, the encoder connects to my streaming service. However, there is no audio, just static(white noise). 

Current configuration: RadioDJ(v2) and Mic into Voicemeeter, Voicemeeter into encoder. Encoder into stream(mp3). All settings are identical. BUTT works fine, SE Caster (static).

Did I miss something in the setup.

Yeah I'm getting that too.
Tried using Virtual Audio Cables and tried Voicemeeter

[ghm72]

I've pulled it from my website wasn't aware that it could cause such issues on some machines.

[TheNerd]

I've pulled it from my website wasn't aware that it could cause such issues on some machines.

Dude!!! Put it back!! It's good!! Just need to adjust AGC in RDJ to Medium or Soft and BOOM!! It is working!!

[FL Coast]

I have been using BUTT with no issues. but it only allows to connect to one stream at a time.

I currently use a paid encoder but,I have used butt 0.1.15 to run 3 stations at once.  You have to create a different configuration file for each instance you run. It's not easy to set up or easy to get back on line if you have a power failure and it shuts your computer down.

The information is located here.  Look under the Configuration

[TheNerd]

Thanks FL!

Not much of a config kind of guy. I did, however get SE Caster encoding and sending good audio.

[country101]

you have to change the titles in the options for them to show up instead of the station name. If the music is working then it is simple as that. If it is always showing the station name then you dont have the .txt enabled in RDJ

[PresidentOfACPJ]

Look at the image below...


Shoudnt SECaster see default audio in my Computer? Its only showing mic options.

[RadioDJ2022]

Go into Windows sound settings from control panel and look to see if Stereo Mix is disabled if it is enable it